The yellow wire will be the hot wire, so connect accordingly.ġ1 – Bolt down the quick release base to the short hub with the supplied screws. The horn connector may need to be bent to accommodate the short hub.ġ0 - Connect the wires from the base of the quick release to the wires coming from the short hub. Bolt the hub in upward position.ĩ – Make sure that the horn contact that was just created contacts the rear of the short hub. The dot signifies that the hub is in the up position. (We’ve also found that other installers have used a variety of things from OEM Shoehorns to cotter pins and conductors.)Ħ- Connect the clip of the horn wire that you ran up to the steering column.ħ – Find a way to bold this wire up to the turn signal/wire switch base.Ĩ – Notice the little dot on the short hub. We had an old hair clip lying around, and that will serve as our horn contact. Run the wire up the steering column.Ĥ – Find something that will conduct electricity that is thin and has good flexibility. Remove the airbag SRS reel, take apart the dash/column panels and disconnect the reel from all wiring harnesses.Ģ – Using a conductivity tester, locate the horn wire on the harness.ģ- Clamp a pin connector to a wire and plug it into the horn wire harness. Refer to vehicle’s service manual for instructions on removing the factory wheel. Note: This install was done on a Sixth generation 96-00 Honda Civicġ – Make Sure the steering wheel is straight, and remove the factory steering wheel and airbag. Some steps were omitted assuming that the installer has basic mechanical knowledge. NRG or Swap Shop Racing is not liable for any damages or possible injuries incurred upon possible accidents due to incorrect installations, bad judgment, and act of nature, etc. This guide is merely for reference and each vehicle may have a different installation process. NRG Innovations & Swap Shop Racing strongly recommends installation of all products from a qualified professional installer. All or these components are available via our website and can be purchased separately or in one of our NRG Quick Release Combo Packages. An optional NRG Quick Lock is also available for added security to your vehicle but is not required.
A Steering Wheel, NRG Short Hub, and of course the NRG Quick Release System. There are three primary pieces need for the NRG Quick Release to function.
NRG Quick Release Install Reference Guide For Gen 1.5,2.0, 2.5, 2.8, & 3.0 Quick Release Kits.
0 kommentar(er)
